C
ONTENTS
– 9 –
Trunk Configuration 144
Configuring a Static Trunk 145
Configuring a Dynamic Trunk 147
Displaying LACP Port Counters 153
Displaying LACP Settings and Status for the Local Side 154
Displaying LACP Settings and Status for the Remote Side 156
Configuring Trunk Mirroring 158
Saving Power 159
Traffic Segmentation 161
Enabling Traffic Segmentation 161
Configuring Uplink and Downlink Ports 162
VLAN Trunking 163
6 VLAN CONFIGURATION 167
IEEE 802.1Q VLANs 167
Configuring VLAN Groups 170
Adding Static Members to VLANs 171
Configuring Dynamic VLAN Registration 176
IEEE 802.1Q Tunneling 179
Enabling QinQ Tunneling on the Switch 183
Adding an Interface to a QinQ Tunnel 184
Protocol VLANs 185
Configuring Protocol VLAN Groups 186
Mapping Protocol Groups to Interfaces 187
Configuring IP Subnet VLANs 189
Configuring MAC-based VLANs 191
Configuring VLAN Mirroring 193
7ADDRESS TABLE SETTINGS 195
Setting Static Addresses 195
Changing the Aging Time 197
Displaying the Dynamic Address Table 198
Clearing the Dynamic Address Table 199
Configuring MAC Address Mirroring 200
8SPANNING TREE ALGORITHM 203
Overview 203
Configuring Loopback Detection 206
Configuring Global Settings for STA 207
To Next Page
Loading...
Need help?
General