C
HAPTER
4
| Configuring the Switch
Quality of Service
– 113 –
The default priority levels are assigned according to
recommendations in the IEEE 802.1p standard as shown in the
following table.
◆ Traffic Class - Output queue buffer. (Range: Low, Normal, Medium
and High, where High is the highest CoS priority queue)
WEB INTERFACE
To configure QoS Control Lists:
1. Click Configuration, QoS, Control Lists.
2. Click the button to add a new QCL, or use the other QCL
modification buttons to specify the editing action (i.e., edit, delete, or
moving the relative position of entry in the list).
3. When editing an entry on the QCE Configuration page, select the QCE
type, specify the relevant criteria to be matched for this type, and set
the traffic class to which traffic matching this criteria will be assigned.
4. Click Save.
Table 10: Mapping CoS Values to Egress Queues
Priority 0123 4 5 67
Queue Normal Low Low Normal Medium Medium High High
To Next Page
Loading...
