C
HAPTER
4
| Configuring the Switch
Setting an IP Address
– 60 –
◆ Router – Sets the IPv6 address of the default next hop router.
An IPv6 default gateway must be defined if the management station is
located in a different IPv6 segment.
An IPv6 default gateway can only be successfully set when a network
interface that directly connects to the gateway has been configured on
the switch.
◆ VLAN ID – ID of the configured VLAN. By default, all ports on the
switch are members of VLAN 1. However, the management station can
be attached to a port belonging to any VLAN, as long as that VLAN has
been assigned an IP address. (Range: 1-4095; Default: 1)
◆ SNTP Server – Sets the IPv6 address for a time server (NTP or SNTP).
The switch attempts to periodically update the time from the specified
server. The polling interval is fixed at 15 minutes.
WEB INTERFACE
To configure an IPv6 address and SNTP in the web interface:
1. Click Configuration, System, IPv6 & Time.
2. Specify the IPv6 settings. The information shown below provides a
example of how to manually configure an IPv6 address.
3. Click Save.
Figure 5: IPv6 & Time Configuration
To Next Page
Loading...
Need help?
General