– 307 –
21 PVLAN COMMANDS
This section describes commands used to configure private VLANs (PVLAN)
and isolated ports, providing port-based security and isolation between
ports within the assigned VLAN.
pvlan configuration This command displays PVLAN member ports, and whether or not port
isolation is enabled.
SYNTAX
pvlan configuration [port-list]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
EXAMPLE
PVLAN>configuration 1-10
Port Isolation
---- ---------
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
6 Disabled
7 Disabled
8 Disabled
9 Disabled
10 Disabled
PVLAN ID Ports
-------- -----
1 1-28
PVLAN>
Table 34: PVLAN Commands
Command Function
pvlan configuration Displays PVLAN member ports, and whether or not port isolation
is enabled
pvlan add Add specified ports to a PVLAN
pvlan delete Deletes the specified PVLAN
pvlan lookup Displays the specified PVLANs and port members
pvlan isolate Displays or sets port isolation between ports within the same
PVLAN
To Next Page
Loading...
Need help?
General