– 311 –
22 QOS COMMANDS
This section describes commands used to configure quality of service
parameters, including the default port queue, the default tag assigned to
untagged frames, input rate limiting, output shaping, queue mode, queue
weight, quality control lists, storm control, DSCP remarking, and DSCP
queue mapping.
Table 35: QoS Commands
Command Function
qos configuration Displays QoS configuration settings, including storm control,
default priority queue, default tag priority, quality control list,
rate limiting, queuing mode and queue weights
qos default Displays or sets default priority (traffic class) for specified ports
qos tagprio Displays or sets default tag priority (used when adding a tag to
untagged frames) for specified ports
qos qcl port Displays or sets the QCL assigned to specified ports
qos qcl add Adds or modifies a QoS control entry
qos qcl delete Deletes a QoS control entry
qos qcl lookup Displays the specified QoS control list or control entry
qos mode Displays or sets the egress queuing mode for specified ports
qos weight Displays or sets the egress queue weight for specified ports
qos rate limiter Displays or sets ingress rate limiting for specified ports
qos shaper Displays or sets egress rate limiting for specified ports
qos storm unicast Displays or sets unknown unicast storm rate limits for the
switch
qos storm multicast Displays or sets multicast storm rate limits for the switch
qos storm broadcast Displays or sets broadcast storm rate limits for the switch
qos dscp remarking Displays or sets the status of DSCP remarking for specified ports
qos dscp queue mapping Displays or sets the DSCP value used for DSCP remarking for
specified ports
To Next Page
Loading...
