C
HAPTER
15
| RSTP Commands
– 259 –
EXAMPLE
RSTP>version compatible
RSTP>
rstp mode This command displays or sets RSTP administrative mode for specified
interfaces.
SYNTAX
rstp mode [port-list] [enable | disable]
port-list - A specific port or a range of ports. (Range: 1-28, all for
all ports, or 0 for all link aggregation groups)
enable - Enables RSTP.
disable - Disables RSTP.
DEFAULT SETTING
Enabled
EXAMPLE
RSTP>mode 19 disable
RSTP>
rstp cost This command displays or sets RSTP path cost for specified interfaces.
SYNTAX
rstp cost [port-list] [path-cost]
port-list - A specific port or a range of ports. (Range: 1-28, all for
all ports, or 0 for all link aggregation groups)
path-cost - The path cost for an interface. (Range: 1-200000000, or
auto for auto-configuration)
DEFAULT SETTING
Auto-configuration
COMMAND USAGE
This parameter is used by the STA to determine the best path between
devices. Therefore, lower values should be assigned to ports attached to
faster media, and higher values assigned to ports with slower media. (Path
cost takes precedence over port priority.)
By default, the system automatically detects the speed and duplex mode
used on each port, and configures the path cost according to the values
shown below.
To Next Page
Loading...
Need help?
General