C
HAPTER
4
| Configuring the Switch
Quality of Service
– 117 –
WEB INTERFACE
To configure Storm Control:
1. Click Configuration, QoS, Storm Control.
2. Enable storm control for unknown unicast, broadcast, or multicast
traffic by marking the Status box next to the required frame type.
3. Select the control rate as a function of 2
n
pps (i.e., a value with no
suffix for the unit of measure) or a rate in Kpps (i.e., a value marked
with the suffix “K”).
4. Click Save.
Figure 29: Storm Control Configuration
To Next Page
Loading...
