C
HAPTER
18
| LLDP Commands
– 290 –
EXAMPLE
LLDP>interval 60
LLDP>
lldp hold This command displays or sets the TTL value sent in LLDP advertisements.
SYNTAX
lldp hold [hold]
hold - The time-to-live (TTL) value sent in LLDP advertisements as
shown in the formula below. (Range: 2-10)
TTL in seconds is based on the following rule:
(Transmission Interval * Transmission Hold Time) ≤ 65536.
Therefore, the default TTL is 30*3 = 90 seconds.
DEFAULT SETTING
3
COMMAND USAGE
The time-to-live tells the receiving LLDP agent how long to retain all
information pertaining to the sending LLDP agent if it does not transmit
updates in a timely manner.
EXAMPLE
LLDP>hold 10
LLDP>
lldp delay This command displays or sets the delay between the successive
transmission of LLDP advertisements.
SYNTAX
lldp delay [delay]
delay - The delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables.
(Range: 1-8192 seconds)
This attribute must comply with the rule:
(4 * Transmission Delay) ≤ Tra ns mission Inter val
DEFAULT SETTING
2 seconds
To Next Page
Loading...
