Edge-Core ES4528V-38 - Entering Commands; Keywords and Arguments

C HAPTER 8 | Using the Command Line Interface
Entering Commands
– 197 –
After entering the Telnet command, the login screen displays:
Username: admin
Password:
Login in progress...
Welcome to Edge-Core Command Line Interface.
Type 'help' or '?' to get help.
Port Numbers:
+-------------------------------------------------------------+
| +--+--+--+--+ +--+--+--+--+ +--+--+--+--+ +----+ +----+ |
| | 1| 3| 5| 7| | 9|11|13|15| |17|19|21|23| | 27 | | 28 | |
| +--+--+--+--+ +--+--+--+--+ +--+--+--+--+ +----+ +----+ |
| | 2| 4| 6| 8| |10|12|14|16| |18|20|22|24| | 25 | | 26 | |
| +--+--+--+--+ +--+--+--+--+ +--+--+--+--+ +----+ +----+ |
+-------------------------------------------------------------+
>
You can open up to four sessions to the device via Telnet.
N OTE : When SSH is enabled, Telnet can't be used.
ENTERING COMMANDS
This section describes how to enter CLI commands.
KEYWORDS AND
ARGUMENTS
A CLI command is a series of keywords and arguments. Keywords identify
a command, and arguments specify configuration parameters. Commands
are organized into functional groups. You can enter the full command from
the main level command prompt “>,” or enter the name of a command
group (e.g., port) and then enter the required command without the group
name prefix.
For example, in the command “port configuration 5,” port configuration
are keywords, and 5 specifies the port.
You can enter commands as follows:
◆ To enter a simple command, enter the command keyword.
◆ To enter multiple commands, enter each command in the required
order. For example, to enable Privileged Exec command mode, and
display the startup configuration, enter:
>port
Port>configuration 5