– 335 –
26 SNMP COMMANDS
This section describes commands used to control access to this switch from
management stations using the Simple Network Management Protocol
(SNMP), including configuring community strings, trap managers, and
basic settings for SNMPv3.
SNMP Version 3 also provides strong security features that cover message
integrity, authentication, and encryption; as well as controlling user access
to specific areas of the MIB tree. To configure management access for
SNMPv3 clients, you need to first create a user, assign the user to a group,
create a view that defines the portions of MIB that the client can read or
write, and then create an access entry with the group and view.
Table 40: SNMP Commands
Command Function
snmp configuration Displays the SNMP configuration settings
snmp mode Displays or sets the SNMP administrative mode
snmp version Displays or sets the SNMP protocol version
snmp read community Displays or sets the community string for SNMP read access
snmp write community Displays or sets the community string for SNMP read/write
access
snmp trap mode Displays or sets the SNMP trap mode
snmp trap version Displays or sets the SNMP trap protocol version
snmp trap community Displays or sets the community string for SNMP traps
snmp trap destination Displays or sets the SNMP trap destination’s IPv4 address
snmp trap ipv6
destination
Displays or sets the SNMP trap destination’s IPv6 address
snmp trap authentication
failure
Displays or sets the SNMP authentication failure trap mode
snmp trap link-up Displays or sets the port link-up and link-down trap mode
snmp trap inform mode Displays or sets the SNMP trap inform mode
snmp trap inform timeout Displays or sets the SNMP trap inform time-out
snmp trap inform retry
times
Displays or sets the SNMP trap inform retry times
snmp trap probe security
engine id
Displays or sets the SNMP trap security engine ID probe mode
snmp trap security engine
id
Displays or sets the SNMP trap security engine ID
snmp trap security name Displays or sets the SNMP trap security name
snmp engine id Displays or sets the SNMPv3 local engine ID
To Next Page
Loading...
