C
HAPTER
25
| Config Commands
– 334 –
config load This command loads configuration settings from a TFTP server to the
switch.
SYNTAX
config load tftp-server file-name [check]
tftp-server - TFTP server’s IP address. Valid IP addresses consist
of four numbers, 0 to 255, separated by periods.
file-name - The name of a previously saved configuration file.
The destination file name should not contain slashes (\ or /), the
leading letter of the file name should not be a period (.) and the
maximum length is 31 characters for files on the switch.
(Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
check - Just check the configuration file for errors, do not apply
DEFAULT SETTING
Check and apply the file.
COMMAND USAGE
You can also restore the factory default settings using the system restore
default command (page 205).
EXAMPLE
Config>load 192.168.2.19 4548v-config
Config>
To Next Page
Loading...
