Edge-Core ES4528V-38 - Snmp Community Lookup; Snmp User Add

C HAPTER 26 | SNMP Commands
– 347 –
DEFAULT SETTING
None
EXAMPLE
SNMP/Community>lookup
Idx Community Source IP Source Mask
--- -------------------------------- --------------- ---------------
1 public 0.0.0.0 0.0.0.0
2 private 0.0.0.0 0.0.0.0
3 r&d 192.168.2.19 255.255.255.0
4 tps 192.168.2.18 255.255.255.0
Number of entries: 4
SNMP/Community>delete 4
SNMP/Community>
snmp community
lookup
This command displays SNMPv3 community entries.
SYNTAX
snmp community lookup [index]
index - Index to SNMP community table. (Range: 1-64)
DEFAULT SETTING
Displays all entries.
EXAMPLE
SNMP/Community>lookup
Idx Community Source IP Source Mask
--- -------------------------------- --------------- ---------------
1 public 0.0.0.0 0.0.0.0
2 private 0.0.0.0 0.0.0.0
3 r&d 192.168.2.19 255.255.255.0
Number of entries: 3
SNMP/Community>
snmp user add This command adds an SNMPv3 user entry.
SYNTAX
snmp user add engine-id user-name [md5 | sha] [auth-password]
[des] [priv-password]
engine-id - The engine identifier for the SNMP agent on the remote
device where the user resides. (Range: 10-64 hex digits, excluding
a string of all 0’s or all F’s)
To send inform messages to an SNMPv3 user on a remote device,
you must first specify the engine identifier for the SNMP agent on
the remote device where the user resides. The remote engine ID is