C
HAPTER
10
| IP Commands
– 215 –
â—† If the IP DHCP option is enabled, the switch will start broadcasting
service requests as soon as it is powered on.
EXAMPLE
IP>dhcp enable
IP>dhcp
DHCP Client : Enabled
Active Configuration:
IP Address : 192.168.0.3
IP Mask : 255.255.255.0
IP Router : 0.0.0.0
DNS Server : 0.0.0.0
SNTP Server :
IP>
ip setup This command displays or sets the switch's IPv4 address and gateway for
the specified VLAN.
SYNTAX
ip setup [ip-addr] [network-mask] [gateway] [vlan-id]
ip-addr - IPv4 address.
network-mask - Network mask for the associated IP subnet. This
mask identifies the host address bits used for routing to specific
subnets.
gateway - IP address of the default gateway.
vlan-id - VLAN to which the management address is assigned.
(Range: 1-4095)
DEFAULT SETTING
IP Address: 192.168.2.10
Network Mask: 255.255.255.0
Gateway: none
VLAN: 1
COMMAND USAGE
N
OTE
:
Only one VLAN interface can be assigned an IP address (the default
is VLAN 1). This defines the management VLAN, the only VLAN through
which you can gain management access to the switch. If you assign an IP
address to any other VLAN, the new IP address overrides the original IP
address and this becomes the new management VLAN.
â—† You must assign an IP address to this device to gain management
access over the network or to connect the switch to existing IP subnets.
You can manually configure a specific IP address, or direct the device to
obtain an address from a DHCP server using the ip dhcp command
(page 214). Valid IP addresses consist of four numbers, 0 to 255,
To Next Page
Loading...
Need help?
General