C
HAPTER
22
| QoS Commands
– 320 –
◆ Due to an ASIC limitation, the enforced rate limits are slightly less than
the listed options. For example: 1 Kpps translates into an enforced
threshold of 1002.1 pps.
EXAMPLE
QoS>Storm>multicast enable 2k
QoS>Storm>
qos storm
broadcast
This command displays or sets broadcast storm rate limits for the switch.
SYNTAX
qos storm broadcast [enable | disable] [packet-rate]
enable - Enables broadcast storm control.
disable - Disables broadcast storm control.
packet-rate - The threshold above which packets are dropped.
(Options: 1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 1024k pps)
DEFAULT SETTING
Disabled
2 pps when enabled
COMMAND USAGE
◆ The specified limit applies to each port.
◆ Any packets exceeding the specified threshold will then be dropped.
◆ Due to an ASIC limitation, the enforced rate limits are slightly less than
the listed options. For example: 1 Kpps translates into an enforced
threshold of 1002.1 pps.
EXAMPLE
QoS>Storm>broadcast enable 2k
QoS>Storm>
qos dscp remarking This command displays or sets the status of DSCP remarking for specified
ports.
SYNTAX
qos dscp remarking [port-list] [enable | disable]
port-list - A specific port or range of ports. (Range: 1-28, or all)
enable - Enables DSCP remarking.
disable - Disables DSCP remarking.
To Next Page
Loading...
