– 363 –
29 UPNP COMMANDS
This section describes commands used to configure Universal Plug and Play
(UPnP) protocol settings.
upnp configuration This command displays UPnP configuration settings.
SYNTAX
upnp configuration
EXAMPLE
UPnP>configuration
UPnP Mode : Disabled
UPnP TTL : 4
UPnP Advertising Duration : 100
UPnP>
upnp mode This command displays or sets UPnP operational mode.
SYNTAX
upnp mode [enable | disable]
enable - Enables UPnP on the switch.
disable - Disables UPnP on the switch.
DEFAULT SETTING
Disabled
COMMAND USAGE
The first step in UPnP networking is discovery. When a device is added to
the network, the UPnP discovery protocol allows that device to broadcast
its services to control points on the network. Similarly, when a control point
Table 44: UPnP Commands
Command Function
upnp configuration Displays UPnP configuration settings
upnp mode Displays or sets UPnP operational mode
upnp ttl Displays or sets the TTL value for UPnP messages
upnp advertising duration Displays or sets the advertising duration of UPnP messages
To Next Page
Loading...
