Edge-Core ES4528V-38 - System Contact; System Name; System Restore Default

C HAPTER 9 | System Commands
– 205 –
system restore
default
This command restores the original factory settings. Note that the LAN IP
Address, Subnet Mask and Gateway IP Address will be reset to their factory
defaults.
SYNTAX
system restore default [keep_ip]
all - Displays a full list of all configuration settings.
DEFAULT SETTING
Restores all settings
EXAMPLE
This example shows how to restore all factory defaults.
System>restore default
System>
system contact This command displays or sets the system contact.
SYNTAX
system contact [contact]
contact - String that describes the system contact information.
(Maximum length: 255 characters)
DEFAULT SETTING
None
COMMAND USAGE
No blank spaces are permitted as part of the contact string.
EXAMPLE
System>contact Maggie
System>
system name This command displays or sets the name assigned to the switch system.
SYNTAX
system name [name]
name - The name of this switch. (Maximum length: 255 characters)