C
HAPTER
15
| RSTP Commands
– 262 –
overcomes other STA-related time-out problems. However, remember that
this feature should only be enabled for ports connected to an end-node
device.
EXAMPLE
RSTP>edge 19 enable
RSTP>
rstp autoedge This command displays or sets RSTP automatic edge port detection for
specified ports.
SYNTAX
rstp autoedge [port-list] [enable | disable]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
enable - Enables automatic edge port detection.
disable - Disables automatic edge port detection.
DEFAULT SETTING
Enabled
COMMAND USAGE
This command controls whether automatic edge detection is enabled on a
bridge port. When enabled, the bridge can determine that a port is at the
edge of the network if no BPDU's received on the port.
EXAMPLE
RSTP>autoedge 19 enable
RSTP>
To Next Page
Loading...
