C
HAPTER
23
| ACL Commands
– 324 –
7 1
8 1
9 1
10 1
11 1
12 1
13 1
14 1
15 1
ACL>
acl action This command displays or sets the default action for specified ports,
including permit/deny, rate limiters, port copy, logging, and shutdown.
SYNTAX
acl action [port-list] [permit | deny] [rate-limiter] [port-copy]
[logging] [shutdown]
port-list - A specific port or range of ports. (Range: 1-28, or all)
permit - Permits a frame if it matches a rule defined in the
assigned policy (see the acl policy command on page 325).
deny - Denies a frame if it matches a rule defined in the assigned
policy (see the acl policy command).
rate-limiter - Specifies a rate limiter (see the acl rate command on
page 325) to apply to the port. (Range: 1-15, or disable)
port-copy - Defines a port to which matching frames are copied.
(Range: 1-28, or disable)
logging - Enables logging of matching frames to the system log.
(Options: log or log_disable)
Use the system log command (page 207) to view any information
stored in the system log for this entry. Related entries will be
displayed under the “info” or “all” logging levels.
shutdown - Shuts down a port when a matching frame is seen.
(Options: shut or shut_disable)
DEFAULT SETTING
Forwarding: Permit
Rate Limiter: Disabled
Port Copy: Disabled
Logging: Disabled
Shutdown: Disabled
EXAMPLE
ACL>action 9 permit 1 15 log shut
ACL>
To Next Page
Loading...
Need help?
General