C
HAPTER
22
| QoS Commands
– 318 –
COMMAND USAGE
Rate limiting controls the maximum rate for traffic transmitted or received
on an interface. Rate limiting can be configured on interfaces at the edge of
a network to form part of the customer service package by limiting traffic
into or out of the switch. Packets that exceed the acceptable amount of
traffic are dropped, while conforming traffic is forwarded without any
changes.
EXAMPLE
QoS>rate limiter enable 600
QoS>
qos shaper This command displays or sets egress rate limiting for specified ports.
SYNTAX
qos shaper [port-list] [enable | disable] [bit-rate]
port-list - A specific port or range of ports. (Range: 1-28, or all)
enable - Enables egress rate limiting.
disable - Disables egress rate limiting.
bit-rate - Maximum egress rate in kilobits/second.
(Range: 500-1000000 kbps)
DEFAULT SETTING
Disabled
500 kbps when enabled
COMMAND USAGE
Rate limiting controls the maximum rate for traffic transmitted or received
on an interface. Rate limiting can be configured on interfaces at the edge of
a network to form part of the customer service package by limiting traffic
into or out of the switch. Packets that exceed the acceptable amount of
traffic are dropped, while conforming traffic is forwarded without any
changes.
EXAMPLE
QoS>shaper enable 600
QoS>
To Next Page
Loading...
