C
HAPTER
31
| Firmware Commands
– 373 –
firmware ipv6 load This command loads new firmware from an IPv6 TFTP server.
SYNTAX
firmware ipv6 load ipv6-tftp-server file-name
ipv6-tftp-server - TFTP server’s IPv6 address. All IPv6 addresses
must be formatted according to RFC 2373 “IPv6 Addressing
Architecture,” using 8 colon-separated 16-bit hexadecimal values.
One double colon may be used in the address to indicate the
appropriate number of zeros required to fill the undefined fields.
file-name - The name of the file to load from the TFTP server. The
destination file name should not contain slashes (\ or /), the leading
letter of the file name should not be a period (.). (Valid characters:
A-Z, a-z, 0-9, “.”, “-”, “_”)
COMMAND USAGE
See the Command Usage section under the firmware load command on
page 371.
EXAMPLE
Firmware>ipv6 load 2001:DB8:2222:7272::72 ES4528V-0_7_smbstax_estax_34.dat
Downloaded "ES4528V-0_7_smbstax_estax_34.dat", 1812567 bytes
.
.
.
RedBoot> go
Username:
To Next Page
Loading...
