– 333 –
25 CONFIG COMMANDS
This section describes commands used to saves or restore configuration
settings.
config save This command saves the switch’s current configuration settings to a file
on a TFTP server.
SYNTAX
config save tftp-server file-name
tftp-server - TFTP server’s IP address. Valid IP addresses consist
of four numbers, 0 to 255, separated by periods.
file-name - The name of the file to store on the TFTP server.
COMMAND USAGE
◆ When you save the system code or configuration settings to a file on
a TFTP server, that file can later be downloaded to the switch to
restore system operation. The success of the file transfer depends on
the accessibility of the TFTP server and the quality of the network
connection.
◆ The configuration file is in XML format. The configuration parameters
are represented as attribute values. When saving the configuration
from the switch, the entire configuration including syntax
descriptions is included in the file. The file may be modified using an
editor and loaded to a switch.
EXAMPLE
Config>save 192.168.2.19 4548v-config
Saved 29683 bytes to server
Config>
Table 39: Configuration Commands
Command Function
config save Saves configuration settings to a TFTP server
config load Loads configuration settings from a TFTP server
To Next Page
Loading...
