C
HAPTER
8
| Using the Command Line Interface
CLI Command Groups
– 201 –
CLI COMMAND GROUPS
The system commands can be broken down into the functional groups
shown below
.
Table 15: Command Group Index
Command Group Description Page
System Configures general system settings, including descriptive
information, user name and password, rebooting the
system, setting the time zone, configuring the log levels
to display, and filtering management access to the switch
through specified IP addresses.
203
IP Configures IP settings, including IPv4 or IPv6 addresses,
DHCP, DNS, DNS proxy, as well as SNTP
213
Auth Controls management access through RADIUS or
TACACS+ authentication servers
223
Port Configures connection parameters for ports, power
saving mode, and cable testing
233
Aggr Configures static port aggregation, including member
assignment, and load balancing methods
243
LACP Configures Link Aggregation Control Protocol 249
RSTP Configures Rapid Spanning Tree Protocol 255
Dot1x Configures IEEE 802.1X Port Authentication 267
IGMP Configures IGMP snooping, query, throttling, and filtering 277
LLDP Configures Link Layer Discovery Protocol 287
MAC Configures the MAC address table, including learning
mode, aging time, and setting static addresses
295
VLAN Configures VLAN port members and port attributes 301
PVLAN Configures private VLANs and isolated ports 307
QoS Configures quality of service parameters, including
default port queue, default tag assigned to untagged
frames, input rate limiting, output shaping, queue mode,
queue weight, quality control lists, storm control, DSCP
remarking, and DSCP queue mapping
311
ACL Configures access control lists, including policies,
responses, and rate limiters
323
Mirror Mirrors data to another port for analysis without affecting
the data passing through or the performance of the
monitored port
331
Config Saves or restores configuration settings 333
SNMP Configures SNMP community strings, trap managers, and
basic settings for SNMPv3
335
HTTPS Enables or disables HTTPS, or automatically redirects
management access from HTTP connections to HTTPS
357
SSH Enables or disables management access via SSH 361
UPnP Configures UPnP protocol settings 363
DHCP Configures DHCP Relay and Option 82 Information 367
To Next Page
Loading...
Need help?
General