Edge-Core ES4528V-38 - 23 ACL Commands

– 323 –
23 ACL COMMANDS
This section describes commands used to configure access control lists,
including policies, responses, and rate limiters.
acl configuration This command displays ACL configuration settings, including policy,
response, rare limiters, port copy, logging, and shutdown.
SYNTAX
acl configuration [port-list]
port-list - A specific port or range of ports. (Range: 1-28, or all)
EXAMPLE
ACL>configuration 1-5
Port Policy Action Rate Limiter Port Copy Logging Shutdown Counter
---- ------ ------ ------------ --------- -------- -------- -------
1 1 Permit Disabled Disabled Disabled Disabled 1463
2 1 Permit Disabled Disabled Disabled Disabled 26429
3 1 Permit Disabled Disabled Disabled Disabled 0
4 1 Permit Disabled Disabled Disabled Disabled 818
5 1 Permit Disabled Disabled Disabled Disabled 818
Rate Limiter Rate
------------ ----
1 1
2 1
3 1
4 1
5 1
6 1
Table 37: ACL Commands
Command Function
acl configuration Displays ACL configuration settings, including policy, response,
rate limiters, port copy, logging, and shutdown
acl action Displays or sets default action for specified ports, including
permit/deny, rare limiters, port copy, logging, and shutdown
acl policy Displays or sets the policy assigned to specified ports
acl rate Displays or sets the rate limiter and maximum packet rate
acl add Adds or modifies an access control entry
acl delete Deletes an access control entry
acl lookup Displays the specified access control entry
acl clear Clears all ACL counters