Edge-Core ES4528V-38 - Displaying Information on Authentication Servers; Displaying a List of Authentication Servers

C HAPTER 5 | Monitoring the Switch
Displaying Information on Authentication Servers
– 157 –
DISPLAYING INFORMATION ON AUTHENTICATION SERVERS
Use the Monitor/Authentication pages to display information on RADIUS
authentication and accounting servers, including the IP address and
statistics for each server.
DISPLAYING A LIST OF
AUTHENTICATION
SERVERS
Use the RADIUS Overview page to display a list of configured
authentication and accounting servers.
PARAMETERS
These parameters are displayed on the RADIUS Overview page:
◆ IP Address - The IP address and UDP port number of this server.
◆ Status - The current state of the server. This field takes one of the
following values:
■
Disabled - The server is disabled.
■
Not Ready - The server is enabled, but IP communication is not yet
up and running.
■
Ready - The server is enabled, IP communication is up and
running, and the RADIUS module is ready to accept access
attempts.
■
Dead (X seconds left) - Access attempts were made to this server,
but it did not reply within the configured timeout. The server has
been temporarily disabled, but will be re-enabled when the dead-
time expires. The number of seconds left before this occurs is
displayed in parentheses.