Edge-Core ES4528V-38 - Lldp Mode; Lldp Optional_Tlv

C HAPTER 18 | LLDP Commands
– 288 –
EXAMPLE
LLDP>configuration 1
Interval : 30
Hold : 3
Tx Delay : 2
Reinit Delay: 2
Port Mode Port Descr System Name System Descr System Capa Mgmt Addr CDP awareness
---- -------- ---------- ----------- ------------ ----------- --------- ------------
1 Disabled Enabled Enabled Enabled Enabled Enabled Disabled
LLDP>
lldp mode This command displays or sets LLDP message transmit and receive modes
for LLDP Protocol Data Units for specified ports.
SYNTAX
igmp mode [port-list] [enable | disable | rx | tx]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
enable - Enables LLDP reception and transmission.
disable - Disables LLDP.
rx - Enables LLDP reception only.
tx - Enables LLDP transmission only.
DEFAULT SETTING
Disabled
EXAMPLE
LLDP>mode enable
LLDP>
lldp optional_tlv This command displays or sets LLDP optional TLVs for specified ports.
SYNTAX
lldp optional_tlv [port-list] [port_descr | sys_name | sys_descr |
sys_capa | mgmt_addr] [enable | disable]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
port_descr - The port description is taken from the ifDescr object
in RFC 2863, which includes information about the manufacturer,
the product name, and the version of the interface hardware/
software.
sys_name - The system name is taken from the sysName object in
RFC 3418, which contains the system's administratively assigned
name. To configure the system name, see page 205.
sys_descr - The system description is taken from the sysDescr
object in RFC 3418, which includes the full name and version