– 255 –
15 RSTP COMMANDS
This section describes commands used to configure the Rapid Spanning
Tree Protocol.
Table 23: RSTP Commands
Command Function
rstp configuration Displays RSTP configuration settings for specified interfaces
rstp sysprio Displays or sets RSTP system priority
rstp age Displays or sets RSTP maximum age
rstp delay Displays or sets RSTP forward delay
rstp txhold Displays or sets RSTP Transmit Hold Count
rstp version Displays or sets RSTP protocol version (RSTP or STP-compatible)
rstp mode Displays or sets RSTP administrative mode for specified interfaces
rstp cost Displays or sets RSTP path cost for specified interfaces
rstp priority Displays or sets RSTP priority for specified interfaces
rstp edge Displays or sets RSTP edge port for specified ports
rstp autoedge Displays or sets RSTP automatic edge detection for specified ports
rstp p2p Displays or sets RSTP point-to-point link type for specified ports
rstp status Displays RSTP operational status for the bridge and any specified
ports or link aggregation groups
rstp statistics Displays RSTP statistics on protocol messages for any specified
ports or link aggregation groups
rstp mcheck Performs RSTP protocol migration check for specified ports
To Next Page
Loading...
Need help?
General