C
HAPTER
4
| Configuring the Switch
Configuring HTTPS
– 88 –
CONFIGURING HTTPS
You can configure the switch to enable the Secure Hypertext Transfer
Protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch's web interface.
USAGE GUIDELINES
â—† If you enable HTTPS, you must indicate this in the URL that you specify
in your browser: https://device[:port-number]
â—† When you start HTTPS, the connection is established in this way:
â–
The client authenticates the server using the server's digital
certificate.
â–
The client and server negotiate a set of security protocols to use for
the connection.
â–
The client and server generate session keys for encrypting and
decrypting data.
â–
The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer
5.x or above, Netscape 6.2 or above, and Mozilla Firefox 2.0.0.0 or
above.
â—† The following web browsers and operating systems currently support
HTTPS:
PARAMETERS
The following parameters are displayed on the HTTPS Configuration page:
â—† Mode - Enables HTTPS service on the switch. (Default: Disabled)
â—† Automatic Redirect - Sets the HTTPS redirect mode operation. When
enabled, management access to the HTTP web interface for the switch
are automatically redirected to HTTPS. (Default: Disabled)
Table 8: HTTPS System Support
Web Browser Operating System
Internet Explorer 5.0 or later Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Windows Vista
Netscape 6.2 or later Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Windows Vista, Solaris
2.6
Mozilla Firefox 2.0.0.0 or
later
Windows 2000, Windows XP, Windows Vista, Linux
To Next Page
Loading...
Need help?
General