Edge-Core ES4528V-38 - Qos Rate Limiter; Qos Weight

C HAPTER 22 | QoS Commands
– 317 –
qos weight This command displays or sets the egress queue weight for specified ports.
SYNTAX
qos weight [port-list] [class] [weight]
port-list - A specific port or range of ports. (Range: 1-28, or all)
class - Output queue buffer. (Range: low/normal/medium/high or
1/2/3/4)
weight - The weight assigned to the specified egress queue, and
thereby to the corresponding traffic priorities. (Range: 1, 2, 4, 8)
DEFAULT SETTING
Low - 1
Normal - 2
Medium - 4
High - 8
COMMAND USAGE
When the Queuing Mode is set to weighted with the qos mode command
(page 316), the switch uses the Weighted Round Robin (WRR) algorithm to
determine the frequency at which it services each priority queue. The
traffic classes are mapped to one of the egress queues provided for each
port. You can assign a weight to each of these queues, and thereby to the
corresponding traffic priorities.
EXAMPLE
QoS>weight 3 8
QoS>
qos rate limiter This command displays or sets ingress rate limiting for specified ports.
SYNTAX
qos rate limiter [port-list] [enable | disable] [bit-rate]
port-list - A specific port or range of ports. (Range: 1-28, or all)
enable - Enables ingress rate limiting.
disable - Disables ingress rate limiting.
bit-rate - Maximum ingress rate in kilobits/second.
(Range: 500-1000000 kbps)
DEFAULT SETTING
Disabled
500 kbps when enabled