– 295 –
19 MAC COMMANDS
This section describes commands used to configure the MAC address table,
including learning mode, aging time, and setting static addresses.
mac configuration This command displays the MAC address table configuration for specified
ports.
SYNTAX
mac configuration [port-list]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
EXAMPLE
MAC>configuration 1
MAC Age Time: 300
Port Learning
---- --------
1 Auto
MAC>
Table 32: MAC Commands
Command Function
mac configuration Displays MAC address table configuration for specified ports
mac add Adds a static MAC address to the specified port and VLAN
mac delete Deletes a MAC address entry from the specified VLAN
mac lookup Searches for the specified MAC address in the specified VLAN
mac agetime Displays or sets the MAC address aging time
mac learning Displays or sets the MAC address learning mode
mac dump Displays sorted list of MAC address entries
mac statistics Displays statistics on the type and number of MAC addresses
associated with specified ports
mac flush Clears all learned entries
To Next Page
Loading...
Need help?
General