Edge-Core ES4528V-38 - 24 Mirror Commands

– 331 –
24 MIRROR COMMANDS
This section describes commands used to mirror data to another port for
analysis without affecting the data passing through or the performance of
the monitored port.
mirror configuration This command displays the port mirroring configuration.
SYNTAX
mirror configuration [port-list]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
EXAMPLE
Mirror>configuration 1-5
Mirror Port: 9
Port Mode
---- --------
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
Mirror>
mirror port This command displays or sets the destination port to which data is
mirrored.
SYNTAX
mirror port [port | disable]
port - The destination port that will mirror the traffic from the
source port. All mirror sessions must share the same destination
port. (Range: 1-28)
disable - Disables mirroring to the destination port.
Table 38: Mirror Commands
Command Function
mirror configuration Displays the port mirroring configuration
mirror port Displays or sets the destination port to which data is mirrored
mirror mode Displays or sets the mirror mode for specified source ports