Edge-Core ES4528V-38 - Snmp Group Add

C HAPTER 26 | SNMP Commands
– 350 –
EXAMPLE
SNMP/User>lookup
Idx Engine ID User Name Level Auth Priv
--- --------- -------------------------------- -------------- ---- ----
1 Remote william Auth, Priv SHA DES
Number of entries: 1
SNMP/User>
snmp group add This command adds an SNMPv3 group entry.
SYNTAX
snmp group add security-model security-name group-name
security-model - The user security model. (Options: v1, v2c, or the
User-based Security Model – usm)
security-name - The name of user connecting to the SNMP agent.
(Range: 1-32 characters, ASCII characters 33-126 only)
The options available for this parameter depend on the selected
Security Model. For SNMP v1 and v2c, the names configured with
the snmp community add command (page 346) can be used. For
USM (or SNMPv3), the names configured with the local engine ID
with the snmp user add command (page 347) can be used. To
modify an entry for USM, the current entry must first be deleted.
group-name - The name of the SNMP group. (Range: 1-32
characters, ASCII characters 33-126 only)
DEFAULT SETTING
None
COMMAND USAGE
◆ An SNMPv3 group sets the access policy for its assigned users,
restricting them to specific read and write views as defined by the snmp
access add command (page 353). You can use the pre-defined default
groups, or create a new group and the views authorized for that group.
◆ Note that the views assigned to a group must be specified with the
snmp view add command (page 352).
EXAMPLE
SNMP>user add 800007e5017f000005 steve sha elephant des hippopotamus
SNMP>group add usm steve tps
SNMP>