Edge-Core ES4528V-38 - Ip Sntp; Ip Ipv6 Autoconfig

C HAPTER 10 | IP Commands
– 218 –
DEFAULT SETTING
Disabled
COMMAND USAGE
If enabled, the switch maintains a local database based on previous
responses to DNS queries forwarded on behalf of attached clients. If the
required information is not in the local database, the switch forwards the
DNS query to a DNS server, stores the response in its local cache for future
reference, and passes the response back to the client.
EXAMPLE
IP>dns_proxy enable
IP>
ip sntp This command displays or sets the IP address for a time server.
SYNTAX
ip sntp [ip-addr]
ip-addr - IP address or IP alias of a time server (NTP or SNTP). An
IPv4 address consists of 4 numbers, 0 to 255, separated by periods.
DEFAULT SETTING
None
COMMAND USAGE
The switch attempts to periodically update the time from the specified
server. The polling interval is fixed at 15 minutes.
EXAMPLE
IP>sntp 192.168.2.19
IP>
ip ipv6 autoconfig This command displays or sets stateless autoconfiguration of IPv6
addresses on an interface and IPv6 functionality on the interface.
SYNTAX
ip ipv6 autoconfig [enable | disable]
enable - Enables IPv6 autoconfiguration mode.
disable - Disables IPv6 autoconfiguration mode.
DEFAULT SETTING
Disabled