– 55 –
4 CONFIGURING THE SWITCH
This chapter describes all of the basic configuration tasks.
CONFIGURING SYSTEM INFORMATION
You can identify the system by configuring the contact information, name,
and location of the switch.
PARAMETERS
These parameters are displayed on the System Information page:
◆ System Contact – Administrator responsible for the system.
(Maximum length: 255 characters)
◆ System Name – Name assigned to the switch system.
(Maximum length: 255 characters)
◆ System Location – Specifies the system location.
(Maximum length: 255 characters)
◆ System Timezone Offset (minutes) – Sets the time zone as an offset
from Greenwich Mean Time (GMT). Negative values indicate a zone
before (east of) GMT, and positive values indicate a zone after (west of)
GMT.
To Next Page
Loading...
Need help?
General