– 357 –
27 HTTPS COMMANDS
This section describes commands used to enables or disable HTTPS, or
automatically redirect management access from HTTP connections to
HTTPS.
https configuration This command displays HTTPS configuration settings.
SYNTAX
https configuration
EXAMPLE
HTTPS>configuration
HTTPS Mode : Disabled
HTTPS Redirect Mode : Disabled
HTTPS>
https mode This command displays or sets HTTPS operational mode.
SYNTAX
https mode [enable | disable]
enable - Enables HTTPS service on the switch.
disable - Disables HTTPS service on the switch.
DEFAULT SETTING
Disabled
COMMAND USAGE
â—† You can configure the switch to enable the Secure Hypertext Transfer
Protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch's web interface.
Table 41: HTTPS Commands
Command Function
https configuration Displays HTTPS configuration settings
https mode Displays or sets HTTPS operational mode
https redirect Displays or sets HTTPS redirect mode from HTTP connections
To Next Page
Loading...
Need help?
General