Edge-Core ES4528V-38 - Figure 28: Rate Limit Configuration

C HAPTER 4 | Configuring the Switch
Quality of Service
– 115 –
◆ Policer Unit - Sets the unit of measure for the port policer.
(Options: kbps, Mbps; Default: kbps)
Egress Limits
◆ Shaper Enabled - Enables or disables egress rate limiting.
(Default: Disabled)
◆ Shaper Rate - Configures the rate for the port shaper.
(Range: 500-1000000 kbps, or 1-1000 Mbps; Default: 500 kbps)
◆ Shaper Unit - Sets the unit of measure for the port shaper.
(Options: kbps, Mbps; Default: kbps)
WEB INTERFACE
To configure Rate Limits:
1. Click Configuration, QoS, Rate Limiters.
2. To set an rate limit on ingress traffic, check Policer Enabled box next to
the required port, set the rate limit in the Policer Rate field, and select
the unit of measure for the traffic rate.
3. To set an rate limit on egress traffic, check Shaper Enabled box next to
the required port, set the rate limit in the Shaper Rate field, and select
the unit of measure for the traffic rate.
4. Click Save.
Figure 28: Rate Limit Configuration