C
HAPTER
9
| System Commands
– 207 –
EXAMPLE
System>password edge
System>
system timezone This command displays or sets the time zone for the switch’s internal clock.
SYNTAX
system timezone [offset]
offset - Number of minutes before/after UTC. (Range: -720 minutes
before to 720 minutes after)
DEFAULT SETTING
no offset
COMMAND USAGE
This command sets the local time zone relative to the Coordinated
Universal Time (UTC, formerly Greenwich Mean Time or GMT), based on
the earth’s prime meridian, zero degrees longitude. To display a time
corresponding to your local time, you must indicate the number of minutes
your time zone is east (before) or west (after) of UTC.
EXAMPLE
System>time -240
System>
system log This command displays log entries, configures the log levels to display, or
clears the log table.
SYNTAX
system log [log-id] [all | info | warning | error] [clear]
log-id - System log ID or range of IDs.
all - Shows all levels.
info - Shows informational messages only.
warning - Shows warning conditions.
error - Shows error conditions.
clear - Clears log messages.
DEFAULT SETTING
Displays all entries
Displays all message levels
To Next Page
Loading...
