Edge-Core ES4528V-38 - Snmp Trap Mode; Snmp Write Community

C HAPTER 26 | SNMP Commands
– 339 –
EXAMPLE
SNMP>read community tps
SNMP>
snmp write
community
This command displays or sets the community string for SNMP read/write
access.
SYNTAX
snmp write community [community]
community - The community used for read/write access to the
SNMP agent. (Range: 0-255 characters, ASCII characters 33-126
only)
DEFAULT SETTING
private
COMMAND USAGE
This parameter only applies to SNMPv1 and SNMPv2c. SNMPv3 uses the
User-based Security Model (USM) for authentication and privacy. This
community string is associated with SNMPv1 or SNMPv2 clients in the
SNMPv3 communities table (see the snmp community lookup command on
page 347).
EXAMPLE
SNMP>write community r&d
SNMP>
snmp trap mode This command displays or sets the SNMP trap mode.
SYNTAX
snmp trap mode [enable | disable]
enable - Enables SNMP traps.
disable - Disables SNMP traps.
DEFAULT SETTING
Disabled
COMMAND USAGE
You should enable SNMP traps so that key events are reported by this
switch to your management station. Traps indicating status changes can be
issued by the switch to the specified trap manager by sending
authentication failure messages and other trap messages.