Edge-Core ES4528V-38 - Qos Storm Multicast; Qos Storm Unicast

C HAPTER 22 | QoS Commands
– 319 –
qos storm unicast This command displays or sets unknown unicast storm rate limits for the
switch.
SYNTAX
qos storm unicast [enable | disable] [packet-rate]
enable - Enables unknown unicast storm control.
disable - Disables unknown unicast storm control.
packet-rate - The threshold above which packets are dropped.
(Options: 1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 1024k pps)
DEFAULT SETTING
Disabled
2 pps when enabled
COMMAND USAGE
◆ The specified limit applies to each port.
◆ Any packets exceeding the specified threshold will then be dropped.
◆ Due to an ASIC limitation, the enforced rate limits are slightly less than
the listed options. For example: 1 Kpps translates into an enforced
threshold of 1002.1 pps.
EXAMPLE
QoS>Storm>unicast enable 2k
QoS>Storm>
qos storm multicast This command displays or sets multicast storm rate limits for the switch.
SYNTAX
qos storm multicast [enable | disable] [packet-rate]
enable - Enables multicast storm control.
disable - Disables multicast storm control.
packet-rate - The threshold above which packets are dropped.
(Options: 1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 1024k pps)
DEFAULT SETTING
Disabled
2 pps when enabled
COMMAND USAGE
◆ The specified limit applies to each port.
◆ Any packets exceeding the specified threshold will then be dropped.