Edge-Core ES4528V-38 - Snmp Mode

C HAPTER 26 | SNMP Commands
– 337 –
Trap Security Engine ID :
Trap Security Name : None
SNMPv3 Engine ID : 800007e5017f000001
SNMPv3 Communities Table:
Idx Community Source IP Source Mask
--- -------------------------------- --------------- ---------------
1 public 0.0.0.0 0.0.0.0
2 private 0.0.0.0 0.0.0.0
3 tps 192.168.2.0 255.255.255.0
Number of entries: 3
SNMPv3 Users Table:
Idx Engine ID User Name Level Auth Priv
--- --------- -------------------------------- -------------- ---- ----
1 Local default_user NoAuth, NoPriv None None
Number of entries: 1
SNMPv3 Groups Table;
Idx Model Security Name Group Name
--- ----- -------------------------------- --------------------------------
1 v1 public default_ro_group
2 v1 private default_rw_group
3 v2c public default_ro_group
4 v2c private default_rw_group
5 usm default_user default_rw_group
Number of entries: 5
SNMPv3 Views Table:
Idx View Name View Type OID Subtree
--- -------------------------------- --------- ---------------------------
1 default_view included .1
Number of entries: 1
SNMPv3 Accesses Table:
Idx Group Name Model Level
--- -------------------------------- ----- --------------
1 default_ro_group any NoAuth, NoPriv
2 default_rw_group any NoAuth, NoPriv
Number of entries: 2
SNMP>
snmp mode This command displays or sets the SNMP administrative mode.
SYNTAX
snmp mode [enable | disable]
enable - Enables SNMP service.
disable - Disables SNMP service.
DEFAULT SETTING
Disabled