Edge-Core ES4528V-38 - Lacp Key; Lacp Role

C HAPTER 14 | LACP Commands
– 252 –
EXAMPLE
LACP>mode 4-7 enable
LACP>mode 1-10
Port Mode
---- --------
1 Disabled
2 Disabled
3 Disabled
4 Enabled
5 Enabled
6 Enabled
7 Enabled
8 Disabled
9 Disabled
10 Disabled
LACP>
lacp key This command displays or sets the LACP administration key for specified
ports.
SYNTAX
lacp key [port-list] [key]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
key - LACP administration key. The key must be set to the same
value for ports that belong to the same LAG. (Range: 0-65535, or
auto)
DEFAULT SETTING
auto - A trunk formed with another switch using LACP will automatically be
assigned the next available trunk ID.
EXAMPLE
LACP>key 11-15 5
LACP>
lacp role This command displays or sets the LACP initiation mode for specified ports.
SYNTAX
lacp role [port-list] [active | passive]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
active - Sends LACP negotiation packets (once each second).
passive - Waits until it receives an LACP protocol packet from a
partner before starting negotiations,