C
HAPTER
4
| Configuring the Switch
Simple Network Management Protocol
– 141 –
CONFIGURING
SNMPV3 GROUP
ACCESS RIGHTS
Use the SNMP Accesses Configuration menu to assign portions of the MIB
tree to which each SNMPv3 group is granted access. You can assign more
than one view to a group to specify access to different portions of the MIB
tree.
PARAMETERS
The following parameters are displayed on the SNMPv3 Access
Configuration page:
â—† Group Name - The name of the SNMP group. (Range: 1-32 characters,
ASCII characters 33-126 only)
â—† Security Model - The user security model. (Options: any, v1, v2c, or
the User-based Security Model – usm; Default: any)
â—† Security Level - The security level assigned to the group:
â–
NoAuth, NoPriv - There is no authentication or encryption used in
SNMP communications. (This is the default for SNMPv3.)
â–
Auth, NoPriv - SNMP communications use authentication, but the
data is not encrypted.
â–
Auth, Priv - SNMP communications use both authentication and
encryption.
â—† Read View Name - The configured view for read access. (Range: 1-32
characters, ASCII characters 33-126 only)
â—† Write View Name - The configured view for write access.
(Range: 1-32 characters, ASCII characters 33-126 only)
To Next Page
Loading...
Need help?
General