Edge-Core ES4528V-38 - Table 30: IGMP Configuration

C HAPTER 17 | IGMP Commands
– 278 –
COMMAND USAGE
The fields shown by this command are described below:
EXAMPLE
IGMP>configuration 1-3
IGMP Mode: Disabled
IGMP Leave Proxy: Disabled
Flooding : Disabled
VID State Querier
---- -------- --------
1 Enabled Disabled
2 Enabled Disabled
Port Router Dynamic Router Fast Leave Group Throttling Number
---- -------- ---------------- ---------- -------------------------
1 Disabled no Disabled Unlimited
2 Disabled no Disabled Unlimited
3 Disabled no Disabled Unlimited
Port Filtering Groups
---- ------------------
1 No Filtering Group
2 No Filtering Group
3 No Filtering Group
IGMP>
Table 30: IGMP Configuration
Field Description
Global Settings
IGMP Mode Shows if IGMP snooping is enabled or disabled
IGMP Leave Proxy Shows if leave messages are suppressed unless received from the
last member port in the group
Flooding Shows if unregistered multicast traffic is flooded into attached VLANs
VLAN Settings
VID VLAN identifier
State Shows if IGMP snooping is enabled or disabled
Querier Shows if the switch can serve as querier on this VLAN
Port Settings
Port Port identifier
Router Shows if a port is set to function as a router port, which leads
towards a Layer 3 multicast device or IGMP querier
Dynamic Router Shows if the switch has detected a Layer 3 multicast device or IGMP
querier on this port
Fast Leave Shows if the switch immediately deletes a member port of a
multicast service if a leave packet is received at that port
Group Throttling
Number
Shows the number of multicast groups to which a port can belong
Filtering Groups Shows the multicast groups that are denied on a port