Edge-Core ES4528V-38 - 11 Authentication Commands

– 223 –
11 AUTHENTICATION COMMANDS
This section describes commands used to controls management access
through RADIUS or TACACS+ authentication servers.
auth configuration This command displays the settings for authentication servers and the
authentication methods used for each access protocol.
SYNTAX
auth configuration
EXAMPLE
The default settings are shown in the following example.
Auth>configuration
Server Timeout : 15 seconds
Server Dead Time : 300 seconds
RADIUS Authentication Server Configuration:
===========================================
Server Mode IP Address Secret Port
------ -------- --------------- ------------------------------ -----
1 Disabled 1812
2 Disabled 1812
3 Disabled 1812
4 Disabled 1812
5 Disabled 1812
Table 18: Authentication Commands
Command Function
auth configuration Displays settings for authentication servers and the
authentication methods used for each access protocol
auth timeout Displays or sets the time the switch waits for a reply from an
authentication server before it resends the request
auth deadtime Displays or sets the time after which the switch considers an
authentication server to be dead if it does not reply
auth radius Displays or sets RADIUS authentication server settings
auth acct_radius Displays or sets RADIUS accounting server settings
auth tacacs+ Displays or sets TACACS+ authentication server settings
auth client Displays or sets the authentication methods used for each
management access protocol
auth statistics Displays statistics for configured authentication and accounting
servers