– 233 –
12 PORT COMMANDS
This section describes commands used to configure connection parameters
for ports, power saving mode, and cable testing.
port configuration This command displays the configuration settings for all ports, a specific
port, or a range of ports.
SYNTAX
port configuration [port-list]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
DEFAULT SETTING
All ports
COMMAND USAGE
The fields shown by this command are described below:
Table 19: Port Commands
Command Function
port configuration Displays configuration settings
port state Displays or sets administrative state to enabled or disabled
port mode Displays or sets port speed and duplex mode
port flow control Displays or sets flow control mode
port maxframe Displays or sets the maximum frame size
port power Displays or sets the power provided to ports based on the length
of the cable used to connect to other devices
port excessive Displays or sets the response to take when excessive transmit
collisions are detected on a port
port statistics Displays port statistics
port veriphy Performs cable diagnostics
port numbers Shows port numbering
Table 20: Port Configuration
Field Description
Port Port index
State Administrative state (Enabled or Disabled)
Mode Port speed and duplex mode (speed/duplex mode or Auto)
To Next Page
Loading...
Need help?
General