C
HAPTER
26
| SNMP Commands
– 344 –
snmp trap probe
security engine id
This command displays or sets the SNMP trap security engine ID probe
mode.
SYNTAX
snmp trap probe security engine id [enable | disable]
enable - Enable SNMP trap security engine ID probe mode,
whereby the switch uses the engine ID of the SNMP trap probe in
trap and inform messages.
disable - Disables SNMP trap security engine ID probe mode.
DEFAULT SETTING
Enabled
EXAMPLE
SNMP/Trap>probe security engine id enable
SNMP/Trap>
snmp trap security
engine id
This command displays or sets the SNMP trap security engine ID.
SYNTAX
snmp trap security engine id [engine-id]
engine-id - Specifies the SNMP trap security engine ID. (Range: 10-
64 hex digits, excluding a string of all 0’s or all F’s)
DEFAULT SETTING
None
COMMAND USAGE
â—† SNMPv3 sends traps and informs using USM for authentication and
privacy. A unique engine ID for these traps and informs is needed.
When trap probe security engine ID is enabled (see page 344), the ID
will be probed automatically. Otherwise, the ID specified by this
command is used.
â—† The Trap Probe Security Engine ID must be disabled (see page 344)
before an engine ID can be manually entered with this command.
EXAMPLE
SNMP/Trap>probe security engine id disable
SNMP/Trap>security engine id 800007e5017f000002
SNMP/Trap>
To Next Page
Loading...
Need help?
General