C
HAPTER
22
| QoS Commands
– 316 –
qos qcl lookup This command displays the specified QoS control list or control entry.
SYNTAX
qos qcl lookup [qcl-id] [qce-id]
qcl-id - A Quality Control List containing one or more classification
criteria used to determine the traffic class to which a frame is
assigned. (Range: 1-28)
qce-id - A QCL entry which specifies one of the following criteria to
be matched in the ingress frame. (Range: 1-24)
DEFAULT SETTING
Displays all QCLs.
EXAMPLE
QoS/QCL>lookup
QCL ID 1:
QCE ID Type Class Mapping
------ ------- -------------
1 VLAN ID 1 -> Low
2 UDP/TCP 0 -> Low
QoS>QCL>
qos mode This command displays or sets the egress queuing mode for specified
ports.
SYNTAX
qos mode [port-list] [strict | weighted]
port-list - A specific port or range of ports. (Range: 1-28, or all)
strict - Services the queues based on a strict rule that requires all
traffic in a higher priority queues to be processed before lower
priority queues are serviced.
weighted - Services the queues based on Weighted Round-Robin
(WRR) queuing that specifies a relative weight of each queue.
DEFAULT SETTING
Strict queuing
EXAMPLE
QoS>mode weighted
QoS>
To Next Page
Loading...
