Edge-Core ES4528V-38 - Configuring Snmpv3 Groups; Figure 36: Snmpv3 Users Configuration

C HAPTER 4 | Configuring the Switch
Simple Network Management Protocol
– 138 –
◆ Privacy Password - A string identifying the privacy pass phrase.
(Range: 8-40 characters, ASCII characters 33-126 only)
WEB INTERFACE
To configure SNMPv3 users:
1. Click Configuration, SNMP, Users.
2. Click Add New User to configure a user name.
3. Enter a remote Engine ID of up to 64 hexadecimal characters
4. Define the user name, security level, authentication and privacy
settings.
5. Click Save.
Figure 36: SNMPv3 Users Configuration
CONFIGURING
SNMPV3 GROUPS
An SNMPv3 group sets the access policy for its assigned users, restricting
them to specific read and write views as defined on the SNMPv3 Access
Configuration page (page 141). You can use the pre-defined default
groups, or create a new group and the views authorized for that group.
PARAMETERS
The following parameters are displayed on the SNMPv3 Groups
Configuration page:
◆ Security Model - The user security model. (Options: SNMP v1, v2c, or
the User-based Security Model – usm).
◆ Security Name - The name of user connecting to the SNMP agent.
(Range: 1-32 characters, ASCII characters 33-126 only)
The options displayed for this parameter depend on the selected
Security Model. For SNMP v1 and v2c, the switch displays the names
configured on the SNMPv3 Communities Configuration menu (see
page 136). For USM (or SNMPv3), the switch displays the names
configured with the local engine ID in the SNMPv3 Users Configuration
menu (see page 137). To modify an entry for USM, the current entry
must first be deleted.