C
HAPTER
4
| Configuring the Switch
Configuring UPnP
– 143 –
If a device has a URL for presentation, then the control point can retrieve a
page from this URL, load the page into a web browser, and depending on
the capabilities of the page, allow a user to control the device and/or view
device status.
Using UPnP under Windows XP - To
access or manage the switch with the aid
of UPnP under Windows XP, open My
Network Places in the Explore file
manager. An entry for “ES3528V” will
appear in the list of discovered devices.
Double-click on this entry to access the
switch's web management interface. Or
right-click on the entry and select
“Properties” to display a list of device
attributes advertised through UPnP.
PARAMETERS
The following parameters are displayed
on the UPnP Configuration page:
◆ Mode - Enables/disables UPnP on the device. (Default: Disabled)
◆ TTL - Sets the time-to-live (TTL) value for UPnP messages transmitted
by the switch. (Range: 4-255; Default: 4)
◆ Advertising Duration - The duration, carried in Simple Service
Discover Protocol (SSDP) packets, which informs a control point or
control points how often it or they should receive a SSDP advertisement
message from this switch. Due to the unreliable nature of UDP, the
switch sends SSDP messages periodically at the interval one-half of the
advertising duration minus 30 seconds. (Range: 100-86400 seconds;
Default: 100 seconds)
To Next Page
Loading...
Need help?
General