C
HAPTER
11
| Authentication Commands
– 227 –
ip-addr - IP address or IP alias of accounting server. An IPv4
address consists of 4 numbers, 0 to 255, separated by periods.
secret - Encryption key shared between the accounting server and
the switch. (Maximum length: 29 characters)
server-port - Network (UDP) port of accounting server used for
accounting messages. (Range: 0-65535, where 0 means that the
switch will use the default port 1813)
To set an empty secret, use two quotes (“”). To use spaces in the
secret, enquote the secret. Quotes in the secret are not allowed.
DEFAULT SETTING
Accounting: Disabled
Server Port: 1813
COMMAND USAGE
The switch supports the following accounting services:
◆ Accounting for users that access the Telnet, SSH or web management
interfaces on the switch.
◆ Accounting for IEEE 802.1X authenticated users that access the
network through the switch. This accounting can be used to provide
reports, auditing, and billing for services that users have accessed.
EXAMPLE
Auth>acct_radius 1 enable 192.168.0.29 bluebird
Auth>acct_radius
RADIUS Accounting Server Configuration:
=======================================
Server Mode IP Address Secret Port
------ -------- --------------- ------------------------------ -----
1 Enabled 192.168.0.29 ******** 1813
2 Disabled 1813
3 Disabled 1813
4 Disabled 1813
5 Disabled 1813
Auth>
To Next Page
Loading...
