C
HAPTER
4
| Configuring the Switch
Filtering IP Addresses for Management Access
– 62 –
PARAMETERS
The following parameters are displayed on the Access Management page:
◆ Mode – Enables or disables filtering of management access based on
configured IP addresses. (Default: Disabled)
◆ Start IP Address – The starting address of a range.
◆ End IP Address – The ending address of a range.
◆ HTTP/HTTPS – Filters IP addresses for access to the web interface
over standard HTTP, or over HTTPS which uses the Secure Socket Layer
(SSL) protocol to provide an encrypted connection.
◆ SNMP – Filters IP addresses for access through SNMP.
◆ TELNET/SSH – Filters IP addresses for access through Telnet, or
through Secure Shell which provides authentication and encryption.
WEB INTERFACE
To configure Access Management controls in the web interface:
1. Click Configuration, System, Access Management.
2. Set the Mode to Enabled.
3. Enter the start and end of an address range.
4. Mark the protocols to restrict based on the specified address range.The
information shown below provides a example of how to restrict
management access for all protocols to a specific address range.
5. Click Save.
Figure 7: Access Management Configuration
To Next Page
Loading...
